KitchenAid 30" Range Hood with the FIT System 설치 가이드

다운로드
페이지 28
10
12. Make Electrical Connection
Option 1 - Direct Wire Installations
 
Use a UL Listed/CSA Approved wire connector 
and connect the 3 white wires (A) together.
 
Use a UL Listed/CSA Approved wire connector 
and connect the 2 black wires (B) together.
 
Connect the green (or bare) ground wire (C) from the 
power supply to the green ground screw in the electrical 
box and tighten the screw securely.
Reinstall the electrical box cover.
Reconnect power.
Option 2 - Power Cord Kit Installations
For optional power cord kit installations, follow the instructions 
supplied with the power cord kit. See the “Assistance or 
Service” section for information on ordering.
NOTE: Use only with range hood cord connection kits that 
have been investigated and found acceptable for use with 
this model range hood.
13. Complete the Installation
 
Install a 120V, 75W maximum, light bulb with 
E26 base. See “Replacing the Light Bulb” in 
the “Range Hood Care” section.
 
If removed previously, replace the filter. See “Metal 
Grease Filter” in the “Range Hood Care” section.
 
Check the operation of the range hood fan and light. 
See the “Range Hood Use” section.
If the range hood does not operate, check to see whether 
a circuit breaker has tripped or a household fuse has blown. 
Disconnect the power and check the wiring connections.
NOTE: To get the most efficient use from your new 
range hood, read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking 
vapors, and odors from the cooktop area. For best results, 
start the hood before cooking and allow it to operate several 
minutes after the cooking is complete to clear all smoke and 
odors from the kitchen.
The hood controls are located on the front panel of 
the range hood.
Range Hood Controls
Operating the light
Press the light switch to the left to turn the light On.
Press the light switch to the right to turn the light Off.
Operating the fan
The fan has 2 speeds.
Press the fan switch to the left for Low speed.
Press the fan switch to the right for High speed.
Return the fan switch to the center to turn the fan Off.
A
B
C
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in 
terminal box.
Failure to do so can result in death, fire, or 
electrical shock.
A
C
B
A.  Light housing and cover
B.  Grease filter retainer
C.  Grease filter
A
B
Off  
On 
Low  
Off
High
A.  On/Off light switch
B.  Fan speed switch