KitchenAid 30" Range Hood with the FIT System 사용 및 관리

Gather the required tools and parts before starting 

installation. Read and follow the instructions provided 

with any tools listed here.

Remove parts from package. Check that all parts are included.

 * For information on ordering, see the “Assistance or Service” 

section.

IMPORTANT: Observe all governing codes and ordinances.

 

■

It is the installer’s responsibility to comply with installation 

clearances specified on the model/serial/rating plate. 

The model/serial/rating plate is located inside the range 

hood on the left wall.

 

■

Range hood location should be away from strong draft 

areas, such as windows, doors, and strong heating vents.

 

■

Cabinet opening dimensions that are shown must be 

used. Given dimensions provide minimum clearance. 

Consult the cooktop/range manufacturer installation 

instructions before making any cutouts.

 

■

This range hood is recommended for use with cooktops 

with a maximum total rating of 50,000 BTUs or less.

 

■

Grounded electrical outlet is required. See “Electrical 

Requirements” section.

 

■

All openings in ceiling and wall where range hood will 

be installed must be sealed.

 

■

These range hoods are factory set for vented installations. 

Models that are capable of being installed as non-vented 

(recirculating) require charcoal filters. See the “Assistance or 

Service” section for information on ordering charcoal filters.

The installation of this range hood must conform to the 

Manufactured Home Construction Safety Standards, Title 

24 CFR, Part 328 (formerly the Federal Standard for Mobile 

Home Construction and Safety, title 24, HUD, Part 280) 

or, when such standard is not applicable, the standard for 

Manufactured Home Installation 1982 (Manufactured Home 

Sites, Communities and Setups) ANSI A225.1/NFPA 501A, 

or latest edition, or with local codes.

Caulking gun and weatherproof
caulking compound

Jigsaw or keyhole saw

Flat-blade
screwdriver

Wire stripper

#2 Phillips
screwdriver

Metal snips

Pencil

#8-18 x 1"
(4.2 x 25 mm) 
flat-head screws

Drywall
anchors

Mounting
brackets

Short Phillips
head screws

Torx   T10 adapter

®†

UL listed/CSA approved 
wire connectors

7" (17.8 cm) 
round 
metal vent 
system with 
wall or roof cap

7" (17.8 cm) 
round damper
Part Number 
W10355451*

Vent clamps as 
required

7" (17.8 cm) 
round vent
mounting plate
Part Number
W10388168*

3¹⁄₄" x 10" 
(8.3 x 25.4 cm) rectangular 
metal vent system with
wall or roof cap

Duct tape

Charcoal 
filter kit 
Part Number 
W10386873*

Power 
cord kit 
Part Number
W10355452*

Stainless steel
cleaner and 
polish 
Part Number 
31462A*

†

®

TORX is a registered trademark of Acument Intellectual Properties, LLC.