KitchenAid 29.5 cu. ft 48-Inch Width Built-In Side by Side Refrigerator with PrintShield™ Finish 설치 가이드

3. Continue adjusting all of the leveling legs to raise the 

refrigerator until the top is within at least 1" (2.54 cm) of 
the top soffit.

NOTE: If an anti-tip board has been used, adjust the leveling 
legs until the top of the refrigerator is within 

¹⁄₄" (6.35 mm) of 

the bottom of the anti-tip board as shown. Do not crush the 
compressor cover.

IMPORTANT: Adjust in small increments to keep from 
damaging the cabinet trim and causing problems with 
the door alignment or top grille fit. To avoid damage to 
the cabinet or leveling legs, do not apply more than 
50 inch-pounds (5.65 Nm) of torque to the leveling bolts. 
The leveling legs can be extended to a maximum of 1

¹⁄₄" 

(3.18 cm) below the rollers. 

4. For Overlay models, additional adjustments may be needed 

after the custom panels are installed.

Install Overlay Series Custom Panels

IMPORTANT: 

■

Install the custom handles prior to installing the panels on the 
refrigerator. For more information on KitchenAid custom 
handle selection, refer to the KitchenAid Catalog, visit 
www.kitchenaid.com, or call 1-800-442-9991. In Canada, 
visit www.KitchenAid.ca, or call 1-800-807-6777.

■

Create custom door overlay panels according to the 
specifications in the “Overlay Series Custom Panels” section.

■

KitchenAid is not responsible for the removal or addition of 
molding or decorative panels that would not allow access to 
the refrigerator for service.

1. Remove all tape and door bracing from the refrigerator and 

freezer doors.

2. Open the refrigerator and freezer compartment doors.

3. Remove the handle-side and top trims.

4. Slide the custom panels into the bottom and hinge side trims 

on the refrigerator compartment and freezer compartment 
doors, making sure that the backer panel fits into the hinge 
side trims.

5. Reinstall the handle-side and top trims.

6. Remove the skin from the screw covers. Slide or snap the 

screw covers into the handle trim section.

7. Check refrigerator level and alignment. Adjust if needed.

¹⁄₄

B

A

C

D

A

A

A

A