Zanussi ZRG15807WA 사용자 설명서

다운로드
페이지 56
What to do if...
Problem
Possible cause
Solution
The appliance does not operate.
The appliance is switched off.
Switch on the appliance.
 
The mains plug is not connec-
ted to the mains socket cor-
rectly.
Connect the mains plug to the
mains socket correctly.
 
There is no voltage in the
mains socket.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
The appliance is noisy.
The appliance is not supported
properly.
Check if the appliance stands sta-
ble.
The lamp does not work.
The lamp is in stand-by.
Close and open the door.
The lamp is defective.
Refer to "Replacing the lamp".
The compressor operates contin-
ually.
Temperature is set incorrectly.
Refer to "Operation" chapter.
 
Many food products were put
in at the same time.
Wait some hours and then check
the temperature again.
 
The room temperature is too
high.
Refer to climate class chart on the
rating plate.
 
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
There is too much frost and ice.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
Refer to "Closing the door".
The water drainage plug is not
correctly positioned.
Position the water drainage plug in
the correct way.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly.
Refer to "Operation" chapter.
Water flows on the rear plate of
the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct.
Water flows inside the refrigera-
tor.
The water outlet is clogged.
Clean the water outlet.
Food products prevent that
water flows into the water col-
lector.
Make sure that food products do
not touch the rear plate.
22
www.zanussi.com