Cisco Cisco Email Security Appliance C390 사용자 가이드
Chapter 6 Managing and Monitoring via the CLI
Managing the Email Queue
6-272
Cisco IronPort AsyncOS 7.3 for Email Daily Management Guide
OL-23080-01
message on the system. You can then optionally use the
removemessage
to safely
remove the message for the given message ID. This command can only remove
messages that are in the work queue, retry queue, or a destination queue. If the
message is in none of these queues, it cannot be removed.
messages that are in the work queue, retry queue, or a destination queue. If the
message is in none of these queues, it cannot be removed.
You can also use the
archivemessage[mid]
CLI command to archive the
message for a given message ID into an mbox file in the configuration directory.
You cannot use the
oldmessage
command to get the message ID for a message in
a system quarantine. However, if you know the message ID, you can show or
archive the specified message. Since the message is not in the work queue, retry
queue, or a destination queue, you cannot remove the message with the
archive the specified message. Since the message is not in the work queue, retry
queue, or a destination queue, you cannot remove the message with the
removemessage
command.
Note
You cannot perform any of these queue management commands on a message in
the IronPort Spam Quarantine.
the IronPort Spam Quarantine.
Syntax
archivemessage
Syntax
oldmessage
example.com> archivemessage
Enter the MID to archive and remove.
[0]> 47
MID 47 has been saved in file oldmessage_47.mbox in the configuration
directory
example.com>
example.com> oldmessage