Cisco Cisco Email Security Appliance C390 사용자 가이드
6-279
Cisco IronPort AsyncOS 7.3 for Email Daily Management Guide
OL-23080-01
Chapter 6 Managing and Monitoring via the CLI
SNMP Monitoring
appliance). After the condition has been met, the SNMP agent then forms an
SNMP packet and sends it over port 162, the standard SNMP trap port. In the
example below, the trap target of
SNMP packet and sends it over port 162, the standard SNMP trap port. In the
example below, the trap target of
snmp-monitor.example.com
and the Trap
Community string are entered. This is the host running the SNMP management
console software that will receive the SNMP traps from the IronPort appliance.
console software that will receive the SNMP traps from the IronPort appliance.
You can configure SNMP traps (enable or disable specific traps) when you enable
SNMP for an interface. To specify multiple trap targets: when prompted for the
trap target, you may enter up to 10 comma separated IP addresses.
SNMP for an interface. To specify multiple trap targets: when prompted for the
trap target, you may enter up to 10 comma separated IP addresses.
CLI Example
In the following example, the
snmpconfig
command is used to enable SNMP on
the “PublicNet” interface on port 161. A passphrase for version 3 is entered and
then re-entered for confirmation. The system is configured to service version 1
and 2 requests, and the community string
then re-entered for confirmation. The system is configured to service version 1
and 2 requests, and the community string
public
is entered for GET requests from
those versions 1 and 2. The trap target of
snmp-monitor.example.com
is entered.
Finally, system location and contact information is entered.
mail3.example.com> snmpconfig
Current SNMP settings:
SNMP Disabled.
Choose the operation you want to perform:
- SETUP - Configure SNMP.
[]> setup
Do you want to enable SNMP? [N]> y
Please choose an IP interface for SNMP requests.