honda-automobiles quicksilver 54 사용자 설명서
To mount the controls to the Kawasaki composite rack, use:
(2) 8mm x 50mm bolts
(2) 5/16” lock washers
(2) 7/8” U-clamp spacers
(2) 5/16” flat washers
Remove the two hold down bolts as shown on previous page. Place the flat washers and
spacers under the control panel base and fasten securely using the lock washer and metric
bolt.
(2) 8mm x 50mm bolts
(2) 5/16” lock washers
(2) 7/8” U-clamp spacers
(2) 5/16” flat washers
Remove the two hold down bolts as shown on previous page. Place the flat washers and
spacers under the control panel base and fasten securely using the lock washer and metric
bolt.
STANDARD TYPE TUBE FRONT RACK
To mount the control panel base to a tube type front rack, use the vinyl covered clamps,
1/4” x 1” bolts, 1/4” flat washers and 1/4” nylock nuts provided and secure it in at least
two points. Refer to the pictures for suggested methods. There are two sizes of clamps
included in the kit to allow the controls to be mounted to virtually any type tube rack.
The control panel is designed to be easily removed using the two clamp knobs. This
allows the control panel base to remain on the ATV when the mower is not in use. See
picture below.
1/4” x 1” bolts, 1/4” flat washers and 1/4” nylock nuts provided and secure it in at least
two points. Refer to the pictures for suggested methods. There are two sizes of clamps
included in the kit to allow the controls to be mounted to virtually any type tube rack.
The control panel is designed to be easily removed using the two clamp knobs. This
allows the control panel base to remain on the ATV when the mower is not in use. See
picture below.
12