Autostart none 사용자 설명서

P. 8 User 

Guide

  

Secure Lock 

Before it can remote-start your vehicle, the remote starter must first disarm the factory security 
system. The secure lock feature may be required on certain vehicle models with factory security 
systems that automatically unlock the doors when the security system is disarmed. 
To keep your vehicle protected when the factory security system is disarmed for a remote start, 
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle 
ends, secure lock will rearm your factory security system. 
Remote Trunk Release 

If your system was installed with the remote trunk release option, you can open your trunk by 
pressing the 

 button.  There will be one beep and LED #3 will flash 3 times. 

The Starter Kill and the Anti-grind Feature 

With this added security feature, the system will prevent your vehicle from starting with the ignition 
key when the starter kill is armed. If your remote starter was installed with the starter kill option, 
one will not be able to start your vehicle with the key unless the system has been unlocked and 
disarmed first, or put into valet mode. 

Note: If the starter kill is installed, your vehicle will benefit from a protection against starter 
motor damage that could occur after remote-starting the engine should the user, by force of 
habit, turn the ignition key to the 

 position. 

Safe Start 

If this feature is enabled, the user must press the 

 button 2 times within 3 seconds to 

remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing 
with the transmitter. 
If swap start mode is selected, to remote-start your vehicle, press the 

button and then the 

 button. The 

 output can be activated by pressing the 

 button. 

Valet Modes 

Valet Mode Using the Valet Switch (if installed) 

1. Turn the ignition key to the 

 position. 

2. Within 3 sec., press the valet button. 

The parking lights will flash three times to indicate that the vehicle is now in valet mode.  

3.  Turn the ignition key to the OFF position. 

The L.E.D. will come 

 solid. 

1. Turn the ignition key to the 

 position. 

2. Within 3 sec., press and release the valet button.  

The parking lights will flash twice to indicate that the vehicle is now out of valet mode. 
3.  Turn the ignition key to the OFF position. 
The L.E.D. will go out. 

Note: Once valet mode is activated, the remote starter functions will be disabled. 

 “Home Valet

TM

” Mode 

If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if 
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.  

Note: Once the home valet mode is activated, the vehicle will not start by remote. 

• 

Press the 

 or 

 button.