Polar CS500 사용자 설명서
Output Sensor user manual.
Changing Cycling Computer Battery
To change the batteries of the cycling computer and transmitter yourself, carefully follow the instructions
below:
below:
When changing the battery, make sure the sealing ring is not damaged, in which case you should replace
it with a new one. Battery kits with sealing rings are available at well-equipped Polar retailers and
authorized Polar Service Centers. In the USA and Canada, the additional sealing rings are available at
authorized Polar Service Centers. In USA the sealing ring/battery kits are also available at
www.shoppolar.com.
it with a new one. Battery kits with sealing rings are available at well-equipped Polar retailers and
authorized Polar Service Centers. In the USA and Canada, the additional sealing rings are available at
authorized Polar Service Centers. In USA the sealing ring/battery kits are also available at
www.shoppolar.com.
1.
Open the battery cover by turning it counter
clockwise 45 degrees (picture 1).
clockwise 45 degrees (picture 1).
2.
Remove the battery cover by lifting it carefully.
The battery is attached to the cover. Remove the
battery. Be careful not to damage the threads of
the back cover and metal spring inside the
battery cover.
The battery is attached to the cover. Remove the
battery. Be careful not to damage the threads of
the back cover and metal spring inside the
battery cover.
3.
Place a new battery with the positive (+) side
against the cover and negative (-) side toward the
cycling computer (picture 2).
against the cover and negative (-) side toward the
cycling computer (picture 2).
4.
The sealing D -ring of the battery cover is
attached to the back cover. Replace the sealing
D -ring if it is damaged. Before closing the
battery cover, make sure that the sealing ring is
undamaged and is placed correctly in its groove.
Ensure that the flat surface of the sealing D –ring
is against the back cover. Otherwise sealing D
–ring might damage when you close the battery
cover.
attached to the back cover. Replace the sealing
D -ring if it is damaged. Before closing the
battery cover, make sure that the sealing ring is
undamaged and is placed correctly in its groove.
Ensure that the flat surface of the sealing D –ring
is against the back cover. Otherwise sealing D
–ring might damage when you close the battery
cover.
5.
Put the battery cover in its place and close it by
turning the cover clockwise (picture 3). Make
sure that the cover is closed properly!
turning the cover clockwise (picture 3). Make
sure that the cover is closed properly!
Transmitter connector
To change the battery yourself, follow below
instructions.
instructions.
1.
Using a coin, open the battery cover by turning it
counterclockwise to OPEN.
counterclockwise to OPEN.
2.
Insert the battery (CR2025) inside the cover with
the positive (+) side against the cover. Make sure
the sealing ring is in the groove to ensure water
resistance.
the positive (+) side against the cover. Make sure
the sealing ring is in the groove to ensure water
resistance.
3.
Press the cover back into the connector.
4.
Use the coin to turn the cover clockwise to
CLOSE.
CLOSE.
Open the cover only when changing the battery to
ensure a long life, and make sure the sealing ring is
not damaged, in which case you should replace it
with a new one.
ensure a long life, and make sure the sealing ring is
not damaged, in which case you should replace it
with a new one.
Battery kits with sealing rings are available at Polar
retailers and authorized Polar Service Centers. In
the USA and Canada, sealing rings are available at
retailers and authorized Polar Service Centers. In
the USA and Canada, sealing rings are available at
ENGLISH
30
Important Information