Philips az3142 사용자 설명서
TROUBLESHOOTING
17
AZ 1140 /17
page
17
English
PROBLEM
– POSSIBLE CAUSE
• REMEDY
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME not adjusted
• Adjust the VOLUME
– VOLUME not adjusted
• Adjust the VOLUME
– Headphones connected
• Disconnect headphones
• Disconnect headphones
– Power cord not securely connected
• Connect the power cord properly
• Connect the power cord properly
Severe radio hum or noise
– Electrical interference: set too close to TV,
– Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
– Weak radio signal
• FM: Direct the FM telescopic antenna for
– Weak radio signal
• FM: Direct the FM telescopic antenna for
optimum reception
• AM: Turn the set for optimum reception
or indication
– No CD inserted
• Insert a CD
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see CD player and
• Replace/ clean CD, see CD player and
CD handling
– Laser lens steamed up,
• Wait until lens has cleared
• Wait until lens has cleared
indication
– CD-R(W) is blank or the disc is not finalised
• Use a finalised CD-R(W)
• Use a finalised CD-R(W)
– CD badly scratched or dirty
• Replace/ clean CD, see CD player and
• Replace/ clean CD, see CD player and
CD handling
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or a program is active
• Switch off SHUFFLE/PROGRAM
• Switch off SHUFFLE/PROGRAM
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
The type plate is located on the bottom of the set.
XP AZ 1140/17 02-02-2000 11:53 Pagina 17