Philips fw-c785 사용자 설명서
23
English
To rewind or fast forward when playback
is stopped
is stopped
1
Press à or á.
2
Press Ç when you reached the desired passage.
To reset tape counter number
●
When in stop mode, pressÇ.
➜ “
➜ “
T1 000” or “T2 000” will be displayed.
Notes:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,TUNER
or AUX, for example).
– The tape counter will automatically set to zero
after detecting end of tape.
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,TUNER
or AUX, for example).
– The tape counter will automatically set to zero
after detecting end of tape.
Dolby B Noise Reduction System
●
Press DOLBY B NR repeatedly to switch on
or off the Dolby B noise reduction system.
➜ If activated,
or off the Dolby B noise reduction system.
➜ If activated,
will appear on the display.
Note:
– A tape recorded with the Dolby B NR system
should also be played in the Dolby B NR mode. If
not, the treble may be reproduced too strongly.
not, the treble may be reproduced too strongly.
General Information on
Recording
Recording
●
For recording, use only tape of IEC type I (normal
tape).
tape).
●
The recording level is set automatically, regardless
of the position of the Volume,VAC, DSC and so
forth.
Dolby B NR can be selected for Tuner or CD
recording.
of the position of the Volume,VAC, DSC and so
forth.
Dolby B NR can be selected for Tuner or CD
recording.
●
The tape is secured at both ends with leader
tape. At the beginning and end
of the tape, nothing will be
recorded for six to seven
seconds.
tape. At the beginning and end
of the tape, nothing will be
recorded for six to seven
seconds.
●
To prevent accidental recording,
break out the tab on the left
shoulder of the tape side you
want to protect.
break out the tab on the left
shoulder of the tape side you
want to protect.
●
If “
CHECK TAPE” is displayed, the protection tab
has been broken. Put a piece of clear adhesive
tape over the opening.
tape over the opening.
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not infringed
upon.
– Recording is possible only on tape deck 2.
– Recording is permissible if copyright or
other rights of third parties are not infringed
upon.
– Recording is possible only on tape deck 2.
Preparation for Recording
1
Press TAPE (TAPE 1•2) to select TAPE 2.
2
Load a recordable tape into tape deck 2.
3
Press í or ë to select the recording tape side.
➜ Ñappears on the display for the reverse side.
➜ Éappears on the display for the forward
➜ Ñappears on the display for the reverse side.
➜ Éappears on the display for the forward
side.
Tape Operation/Recording
pg 01-30/C785/34-Eng 12/27/01 10:19 AM Page 23