GE SPBD880 사용자 설명서
10
Consumer
S
uppor
t
Tr
oubleshooting
Tips
Operating
Instructions
Safety
Instructions
Installation
Instructions
Using the SmartDispense
™
pedestal.
To Fill Your Fabric Softener Tank:
1. Open the tank for filling by turning the cap
counterclockwise until the cap is loose. Lift
the cap off.
the cap off.
NOTE: Do not fill the tank while it is
removed from the drawer. Fluid may
be lost while reattaching the tank
to the SmartDispense system.
removed from the drawer. Fluid may
be lost while reattaching the tank
to the SmartDispense system.
2. Aim the fabric softener bottle at the
opening in the tank and begin to fill.
The fabric softener tank will hold 80 oz.
of concentrated liquid fabric softener.
The system requires that at least
12 ounces of new fabric softener
must be added to the tank to
recognize that it has been filled.
The fabric softener tank will hold 80 oz.
of concentrated liquid fabric softener.
The system requires that at least
12 ounces of new fabric softener
must be added to the tank to
recognize that it has been filled.
3. When full, replace the cap and turn
clockwise until tight to ensure proper
sealing. If residue is left on the tank, wipe
clean with a moist cloth, using a mild soap.
sealing. If residue is left on the tank, wipe
clean with a moist cloth, using a mild soap.
4. An indicator will appear on the washer
control panel to notify you when the
dispenser needs to be filled again. After
filling the tank, the warning message
will turn off when the washer is powered
on for the next cycle. A full tank using
concentrated liquid fabric softener
will last approximately 3 months
for the average user.
dispenser needs to be filled again. After
filling the tank, the warning message
will turn off when the washer is powered
on for the next cycle. A full tank using
concentrated liquid fabric softener
will last approximately 3 months
for the average user.
NOTE: The fabric softener sensor should be
wiped clean every time the tank needs to be
refilled. To remove the fabric softener sensor
while the drawer is fully opened, grasp the
sensor at the rear of the tank, using the grip
provided, and pull the sensor straight up.
Wipe the surface of the sensor, using a moist
cloth with a mild soap; then replace the
sensor back in its original position.
wiped clean every time the tank needs to be
refilled. To remove the fabric softener sensor
while the drawer is fully opened, grasp the
sensor at the rear of the tank, using the grip
provided, and pull the sensor straight up.
Wipe the surface of the sensor, using a moist
cloth with a mild soap; then replace the
sensor back in its original position.
Fabric softener tank
FABRIC SOFTENER LOW
0:48