GE wisq416d 사용자 설명서

Washer is unplugged

Make sure cord is plugged securely into a

working outlet.

Water supply is turned off

Turn both hot and cold taps fully on.

Controls are not set properly

Check controls and make sure Cycle knob

is pulled out to ON position.

Lid is open

Close lid and pull Cycle knob out to ON 

position.

Circuit breaker/fuse is 

Check house circuit breakers/fuses. Replace

tripped/blown

fuses or reset breaker. Washer should have 

separate outlet.

Drain hose is kinked or

Straighten drain hose and make sure 

improperly connected

washer is not sitting on it.

Top of drain outlet should be less than 

1m (3 ft.) above floor.

Control is not set properly

Check water temperature control and adjust.

Water supply is turned off 

Turn both hot and cold taps fully on and 

or improperly connected

make sure hoses are connected to correct 

taps.

Water valve screens are 

Turn off the water source and remove the 

stopped up

water connection hoses from the upper back

of the washer. Use a brush or toothpick to 

clean the screens in the machine. Reconnect

the hoses and turn the water source back on.

House water heater is not set

Make sure house water heater is delivering

properly

water at 48°C.–65°C. (120°F.–150°F.).