honda-automobiles ct110 사용자 설명서
STORAGE GUIDE
Extended storage, such as for winter, requires that you take certain steps to reduce the effects of
deterioration from non-use of the motorcycle. In addition, necessary repairs should be made BEFORE
deterioration from non-use of the motorcycle. In addition, necessary repairs should be made BEFORE
storing the motorcycle; otherwise, these repairs may be forgotten by the time the motorcycle is
removed from storage.
removed from storage.
STORAGE
1. Change the engine oil.
2. Drain the fuel tank and carburetor. Spray the inside of the fuel tank with an aerosol rust-
inhibiting oil. Reinstall the fuel fill cap on the tank.
NOTE
If storage will last more than one month, carburetor draining is very
important, to assure proper performance after storage.
important, to assure proper performance after storage.
WARNING
Petrol is extremely flammable and is explosive under certain conditions.
Perform this operation in a well-ventilated area with the engine
Perform this operation in a well-ventilated area with the engine
stopped. Do not smoke or allow flames or sparks in the area where
petrol is drained or stored and where the fuel tank is refueled.
petrol is drained or stored and where the fuel tank is refueled.
3. Remove the spark plug and pour a tablespoon ( 15 - 20 cm
3
) of clean engine oil into the
cylinder. Operate the kick starter several times to distribute the oil. spark plug.
NOTE
When turning the engine over, the Ignition Switch should be OFF and the
spark plug placed in its cable cap and grounded to prevent damage to the
spark plug placed in its cable cap and grounded to prevent damage to the
ignition system.
4. Remove the battery. Store in an area protected from freezing temperatures and direct sunlight.
Check the electrolyte level and slow charge the battery once a month.
5. Wash and dry the motorcycle. Wax all painted surfaces.
6. Lubricate the drive chain.
7. Inflate the tyres to their recommended pressures. Place the motorcycle on blocks to raise both
7. Inflate the tyres to their recommended pressures. Place the motorcycle on blocks to raise both
tyres off the ground.
8. Cover the motorcycle ( don't use plastic or other coated materials ) and store in an unheated
area, free of dampness with a minimum of daily temperature variation. Do not store the
motorcycle in direct sunlight.
motorcycle in direct sunlight.