Harbor Freight Tools 420 cc 사용자 설명서

Page 6

Horizontal Engines 

        

to fire prevention requirements.
At high altitudes, the engine’s carburetor, governor 

(if so equipped), and any other parts that control 

the fuel-air ratio will need to be adjusted by a 

qualified mechanic to allow efficient high-altitude 

use and to prevent damage to the engine and 

any other devices used with this product.

Model 68120: The emission control system for this 

engine is warranted for standards set by the U.S. 

Environmental Protection Agency.  For warranty 

information, refer to the last pages of this manual. 
Models 68306, 68121, and 68136: The emission 

control system for this Generator’s Engine is 

warranted for standards set by the U.S. Environmental 

Protection Agency and by the California Air Resources 

Board (also known as CARB).  For warranty 

information, refer to the last pages of this manual.
WARNING!  DO NOT INSTALL THIS 

1.  Place a 

fully charged, lead-acid 12 volt, 

300 CCA, 36 Ah battery (not included) in 

a stable, flat location near the engine.

2.  Only use cables sized to match their length 

according to the following chart:

3. 

Starting Relay

Motor Starter Assembly

Attach the positive cable from the positive 

battery terminal to the Positive Terminal on 

the starter solenoid (

uncovered terminal), 

shown above.  Connect cable securely to 

prevent disconnection and short circuits.

4.  Attach the negative cable to the 

negative battery terminal.

5.  Connect the negative cable securely to one 

of the engine 

mounting bolts, as shown in 

the diagram below. Connect cable securely to 

prevent disconnection and short circuits.

6.  Coat the terminals and cable ends with 

a corrosion-preventive coating.