Hanna Instruments hi 9017 사용자 설명서

Data transmission from the instrument to
the PC is now much easier with the new
HI92000 Windows

compatible applica-

tion software offered by Hanna Instruments.
User friendly, HI92000 offers a variety of
features and has an on line help feature to
support you throughout all situations.
HI92000 allows you to use the powerful means of the most diffused
spread sheet programs (e.g. Excel

, Lotus 1-2-3

). Simply run your

favorite spread sheet and open the file downloaded by HI92000. It is
then possible to make any elaboration available with your software
(e.g. graphics, statistical analysis).
To install HI92000 you need a 3.5" drive and few minutes to follow
the instructions conveniently printed on the disk’s label.
Contact your Hanna Dealer to request a copy.
To connect your Hanna Instruments bench meter to the PC use
HI920010, available through your Hanna Dealer. Make sure that your
meter is switched off and plug the connectors, one into the meter
RS232C connector, the other into the serial port of your PC.
Note: Cables different from the HI920010 may use a different con-

figuration. In such case any communication between the meter
and the PC is not possible.

SETTING THE BAUD RATE

The transmission speed (baud rate) of the meter and the external
device must be identical. The meter is factory set to 1200.
If you wish to change this value, please contact your nearest Hanna
Center.

SENDING COMMANDS FROM PC

With terminal programs such as, for example, Telix

, Windows Termi-

nal

, it is possible to remotely control your Hanna Instruments bench

meter. Use HI920010 cable to connect the meter to the PC, start the
terminal program and set the communication options as follows: 8, N,
1, no flow control.

COMMAND TYPES

To send a command to the pH meter the scheme is:
<DLE> <command> <CR>

Windows® and Windows Terminal ® are registered Trademark of "Microsoft Co."

TELIX® is registered Trademark of "Deltacomm"

INTERFACE WITH COMPUTER