Hanna Instruments hi 9224 사용자 설명서
32
When the batteries are run down
"LOBAT" is displayed on the Liquid
Crystal Display to warn the user.
Battery replacement must only take
place in a non hazardous area using
1.5V alkaline AA type batteries .
In order to replace run down batter-
ies, simply remove the two screws on
the rear cover of the instrument and
replace the four 1.5V AA batteries
with new ones, paying attention to
the correct polarity.
"LOBAT" is displayed on the Liquid
Crystal Display to warn the user.
Battery replacement must only take
place in a non hazardous area using
1.5V alkaline AA type batteries .
In order to replace run down batter-
ies, simply remove the two screws on
the rear cover of the instrument and
replace the four 1.5V AA batteries
with new ones, paying attention to
the correct polarity.
A 12VDC power source can also be
used to power the unit (see the Acces-
sories section page 40).
used to power the unit (see the Acces-
sories section page 40).
Note The instrument uses the following configuration.
It is recommendable to purchase the Hanna HI710005 and HI710006
voltage adapters that use the proper polarity configuration.
Anyway, HI 9224 and HI 92240 can be used with other adapters.
In this case, remember to check the correct polarity of your adapter
before connecting it to the meter.
voltage adapters that use the proper polarity configuration.
Anyway, HI 9224 and HI 92240 can be used with other adapters.
In this case, remember to check the correct polarity of your adapter
before connecting it to the meter.
+
-
LO BAT
pH
-
-
+
+
1.5V
1.5V
-
-
+
+
1.5V
1.5V
SCREW
POTS
RESET
BATTERY REPLACEMENT