Behringer Eurodesk SX4882 사용자 설명서

EURODESK SX4882

Connections

12

Expander port bus inputs
If you want to add another console to your EURODESK SX4882, 

the expander port bus inputs give access to all subgroups, auxes 

and mix busses via an array of 1/4" jacks, situated top left on the 

rear panel.

Auxiliary sends
Unbalanced  1/4"  jacks,  wired  tip  =  signal  (+ve)  and  sleeve  = 

ground/screen. They operate at +4 dBu.

Auxiliary returns
All six stereo pairs, to be located immediately below the aux sends, 

are on unbalanced 1/4" jacks and operate at 0 dBu.

Subgroup inserts
Unbalanced send and return from a single stereo jack socket, 

wired tip = out, ring = in and sleeve = ground/screen.

2-track in/out
RCA sockets for use with tape recorders, etc., signal = main mix, 

wired center post = signal (+ve) and sleeve = ground/screen.

2-track/external inputs
Two additional stereo inputs, this time on unbalanced 1/4" jacks, 

wired tip = signal (+ve) and sleeve = ground/screen.

Main inserts
As above, but for the main mix.
Stereo outputs
The control room output (monitors) main mix, MIX-B and studio 

output are all on a pair of unbalanced 1/4" jacks, nominal output 

level +4 dBu. The main mix is also available as a fully balanced 

pair.
Phones 1/2
These are on stereo jacks, wired tip = left signal, ring = right signal 

and sleeve = ground/screen (see section 6.4 “Headphones”).
Meter/analyzer out
Unbalanced  jacks  at  +4  dBu  for  use  with  external  measur-

ing  equipment,  e.g.  the  built-in  real-time  analyzer  of  our 

BEHRINGER  ULTRACURVE  PRO  DEQ2496  (signal  =  master 

LED meters).
Master balanced outputs
Balanced XLR for connecting to the mastering recorder. Wired 

pin 1 ground/screen, pin 2 hot and pin 3 cold. Maximum level is 

+28 dBu.