Indesit pwe 8168 w 사용자 설명서

다운로드
페이지 84
3
GB
Connecting the drain hose
Connect  the  drain  hose,
without bending it, to a
drain duct or a wall drain
situated  between  65  and
100 cm from the floor;
alternatively,  place  it
over the edge of a
basin, sink or tub,
fastening  the  duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
 We advise against the use of hose extensions; if it is
absolutely  necessary,  the  extension  must  have  the
same diameter as the original hose and must not
exceed 150 cm in length.
Electrical  connections
Before plugging the appliance into the electricity
socket,  make  sure  that:
• the socket is earthed and complies with all
applicable  laws;
• the  socket  is  able  to  withstand  the  maximum
power load of the appliance as indicated in the
Technical  data  table  (see  opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washing  machine.  If  this  is  not  the  case,  replace  the
socket or the plug.
 The washing machine must not be installed
outdoors,  even  in  covered  areas.  It  is  extremely
dangerous to leave the appliance exposed to rain,
storms  and  other  weather  conditions.
  When  the  washing  machine  has  been  installed,  the
electricity  socket  must  remain  within  easy  reach.
 Do not use extension cords or multiple sockets.
65 - 100 cm
 The cable should not be bent or compressed.
 The power supply cable must only be replaced by
authorised  technicians.
Warning! The company shall not be held responsible
in  the  event  that  these  standards  are  not  observed.
The first wash cycle
Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with
detergent and no laundry, using wash cycle number 2.
 
Technical data
 
Model
 
PW E 8168 W
 
Dimensions
 
width 59.5 cm 
height 85 cm 
depth 62 cm
 
Capacity
 
between 1 and 8 kg 
 
Electrical 
connections
 
please refer to the technical data  
plate applied to the machine
 
Water connections
 
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa  
(0.5 bar) 
drum capacity 62 litres
 
Spin speed
 
up to 1600 rpm
 
Test wash cycles 
in compliance with 
regulation  
EN 60456
 
wash cycle 2; temperature 60°C; 
performed with a 8 kg load.
 
 
This appliance conforms to the 
following European Community 
directives: 
- 89/336/EEC dated 03.05.89 
(Electromagnetic Compatibility)  
and subsequent amendments 
- 2006/95/EC – 2006/95/EC (Low 
Voltage)