Microboards Technology hcl-6000 사용자 설명서

• Troubleshooting 

 

10 

Arm did not return to 
top position 

The vacuum picking arm did not return to the top position within 10 
seconds after a command was sent out. The vacuum picking arm 
must return to the top position after each action. This indicates an 
obstruction or mechanical failure prevented the vacuum picking arm 
from completing the requested action. 

11 

Arm did not detect 
specified location in the 
allotted time 

when the vacuum picking arm has failed to detect anything 
(including the bottom of the bin) within 10 seconds after attempting 
to pick up a disc. This would apply to inserting a disc in a drive and 
not detecting anything within 10 seconds if the Z Maneuver feature 
is disabled.  This error indicates that an obstruction, missing 
component or mechanical failure has prevented the vacuum picking 
arm from detecting a disc, drive, etc to perform the assigned task. 

12 

Unable to move to the 
next input/output bin 

The vacuum picking arm did not travel to its destination input/output 
bin from any other bin within 10 seconds. This error indicates that an 
obstruction or mechanical failure has prevented the vacuum picking 
arm from rotating to the assigned input/output bin. 

13 

Unable to move into the 
drop disc position 

The vacuum picking arm did not reach the “drop” position within 4 
seconds when placing a disc to output bin. The “drop” position 
represents the safe distance between the vacuum picking arm and 
the spindle where the disc can be placed securely onto the spindle. 
This error indicates that an obstruction, missing component or 
mechanical failure has prevented the vacuum picking arm from 
performing the assigned task. 

14 

Unable to perform the 
horizontal Z Maneuver 
from bin # 1 to the 
starting point 

The vacuum picking arm did not reach the horizontal starting 
position for placing a disc into the appropriate drive starting from 
spindle bin #1 within 4 seconds during the insert process. (This error 
is only shown when the Z Maneuver is enabled).  

15 

Unable to perform the 
horizontal Z Maneuver 
from the starting point 
to the original position 

The vacuum picking arm did not reach the drive position within 4 
seconds from the Z position starting point. This takes place when the 
vacuum picking arm has descended to the appropriate drive location 
and should move horizontally to center the disc over the opened 
drive tray but fails to do so in the specified allotted time. (This error 
is only shown when the Z Maneuver is enabled). 

16  Unable to perform 

vertical Z Maneuver 
while placing disc in 
drive tray 

The vacuum picking arm did not descend and place the disc into the 
opened drive tray within 4 seconds after the vacuum picking arm has 
centered the disc above the opened drive tray. (this error is only 
shown when the Z Maneuver is enabled). 

17 

Unable to perform the 
horizontal Z Maneuver 
from the original 
position to the starting 
point  

The vacuum picking arm did not return to starting horizontal position 
for the reverse Z Maneuver within 4 seconds to return the disc to the 
output bin. (This error is only shown when the Z Maneuver is 
enabled). 

20 

Input bin empty 

All of the input bins are empty. This error commonly comes up every 
time the autoloader does not detect any more blank media to load 
into the drives. If this error arises and you are finished, press the left 
arrow to end the copy process. If you are not finished, restack the 
blank media from the first input bin to the remaining bins as needed 
and push the right arrow key to continue the duplicating procedure. 

21 

Input bin missing 

The current input bin is missing. This error indicates that an 
obstruction, missing component or mechanical failure has prevented 
the vacuum picking arm from detecting the input bin to perform the 
assigned task.