Microboards Technology hcl-6000 사용자 설명서

 

 

 

 

The Microboards HCL Series autoloader has five spindles (see Figure 
1-2) that hold approximately 250 discs each; variations in media 
thickness between brands will change the number of discs you can 
load at any one time. 

Initially, Spindle 1 will be left empty. The robotic arm picks blank discs 
from Spindle 2 first, and places the successful copies onto Spindle 1. 
Once Spindle 2 is empty, it picks blank discs from Spindle 3, and 
places the successful copies onto Spindle 2. It then picks from 
Spindle 4 and places onto Spindle 3, and then picks from Spindle 5 
and places onto Spindle 4. Reject discs are placed on to the deck 
below the drive trays. (Throughout this manual, this area is also 
referred as “Reject Area”).  

 

 

Figure 1-3 shows the LCD Control Panel. This panel 
has a two-line, 20 character LCD display to provide 
user feedback. Eight push buttons control the 
operation of the Microboards HCL Series. The 
functions for these buttons are shown in Table 1-1.  

 

 

 

Control  

Name 

Function  

 

Up 

Scroll up through the menu or list.  

 

Down 

Scroll down through the menu or list.  

 

OK 

Execute the function. Also called OK in the Menus.  

 

ESC 

Go back to the previous function. 

Copy 

Quick key to make a copy. Pressing this key takes you directly to the 1. Copy 
menu.  

Hard 

Drive 

Quick key to access the hard drive utilities. Pressing this key takes you directly 
to the 10. Hard Drive Setup menu. 

Single 

Master 

Quick key to change the Master Mode to SINGLE. Pressing this sets the unit in 
Single Master Mode without going into the 8. Master Mode menu..  

Multi 

Master 

Quick key to change the Master Mode to MULTI. Pressing this sets the unit in 
Multi Master Mode without going into the 8. Master Mode menu.