McAfee firewall 2.1-getting started 사용자 설명서

28

McAfee Firewall

The System Settings must be verified after changes are made to network 
devices. This is especially important if a network device is added or removed. 
If a device was removed, all settings may have to be re-entered, because they 
previous settings may now be associated with the wrong device. If a device is 
added, it will have to be configured for the first time.

1. Select the Settings menu item, and the System option on the popup menu.

2. For each network device:

•

Choose the device in the list and choose Properties.

•

Confirm that the settings shown are your choice. Makes changes where 
necessary.

•

Choose OK when done. Note: changes take effect for this device when 
you choose OK on the Properties page. Choosing Cancel on the 
System/Settings page does not cancel these changes. If in doubt, review 
the settings later to confirm.

3. Choose OK to close the System/Settings dialog box.

The following steps will help the Administrator protect the configuration. 
Without using password protection, the only way to make sure that setup has 
not been altered is to examine all settings. By using password protection, you 
will be notified if the setup file was altered.

1. Select the File menu item, and the "Password" option on the popup menu. 

This pops up another menu. Select "Set".

2. Enter a secret password in the two places shown and choose OK.

3. Write the password down and store it in a safe place. There is no 

mechanism for retrieving the password once it is lost.

The next time the program is run, it will prompt for the password to be 
entered. If it is not entered (you can simply hit the <Esc> key), the control 
functions are disabled (shown in gray) and the setup cannot be changed. Once 
the correct password is entered, the control functions  may be used.