Panasonic SV-P10U 작동 가이드
10
1
2
1
4
3
2
1
3
1
4
2, 3
5
4
Inserting the Ink Cassette
1
Turn it in the direction of the arrow to clear
any slack in
the Ink Film.
2
Open
Ink Cassette Compartment Door
1
.
3
Push it into the direction shown by the arrow until it
clicks into place.
clicks into place.
≥The insert guide (blue)
2
will come off.
≥At the first time, insert together with the insert guide
2
. At the
second time and thereafter, the insert guide is not necessary.
4
Close
1
.
Ejecting the Ink Cassette
Slide the [
] Lever
3
to take out the Ink Cassette.
≥Do not touch the Ink Film in the Ink Cassette, and do not pull it out of
the cassette.
≥It is recommended that you do not pull out the Ink Cassette before the
full consumption of ink, because the Ink Film may sag when resetting
the Ink Cassette.
the Ink Cassette.
≥Confirm that there is no paper and then remove or replace the Ink
Cassette.
≥Close the Ink Cassette Compartment Door during printing.
≥Do not eject the Ink Cassette during printing.
≥When removing the Ink Cassette, pack it back into its original case.
≥Do not eject the Ink Cassette during printing.
≥When removing the Ink Cassette, pack it back into its original case.
Inserting a SD Memory Card/ MultiMediaCard
1
Slide the Memory Card Door
4
, and flip it to open.
2
Hold the Memory Card placing the cut off corner
5
at
the front with the label facing up, and then insert it fully
into the Memory Card Slot horizontally.
into the Memory Card Slot horizontally.
≥When inserted appropriately, a clicking noise may sound.
3
Close the Memory Card Door
4
.
≥After inserting the Memory Card, reverse the procedure in step 2 to
close the Memory Card Door.
Removing the Card
Open the Memory Card Door and push the edge of the card to
remove it.
remove it.
≥Insert/remove cards only when the power is off.
≥Only an SD Memory card or MultiMediaCard can be used for this
≥Only an SD Memory card or MultiMediaCard can be used for this
printer.
≥Do not touch the terminals on the back of the Card with your fingers.
Do not allow dirt, dust or water to contact the terminals.
≥If the Memory Card Door is not closed completely, remove the Memory
Card once and re-insert it.
≥It may take a long time to read depending on the images in the Card
([ACCESS] Lamp lights while reading).For example, it takes about 40
seconds to read a JPEG image of four million pixels.
seconds to read a JPEG image of four million pixels.
Inserting the Ink Cassette
Inserting a D Memory Card/
MultiMediaCard
MultiMediaCard
Removing the Card
SDP1U.book 10 ページ 2002年1月28日 月曜日 午後7時48分