DJI Phantom 3 4K 사용자 매뉴얼

Aircraft

Phantom 3 4K User Manual

The performance of your Vision Positioning System is affected by the surface over which it is

flying. The ultrasonic sensors may not be able to accurately measure distances when operating

above sound-absorbing materials. In addition, the camera may not function correctly in

suboptimal environments. The aircraft will switch from P-mode to A-mode automatically if neither

GPS nor Vision Positioning System are available. Operate the aircraft with great caution in the

following situations:

Flying over monochrome surfaces (e.g. pure black, pure white, pure red, pure green).

Flying over a highly reflective surfaces.

Flying at high speeds(over 8 m/s at 2 meters or over 4 m/s at 1 meter).

Flying over water or transparent surfaces.

Flying over moving surfaces or objects.

Flying in an area where the lighting changes frequently or drastically.

Flying over extremely dark (lux < 10) or bright (lux > 100,000) surfaces.

Flying over surfaces that can absorb sound waves (e.g. thick carpet).

Flying over surfaces without clear patterns or texture.

Flying over surfaces with identical repeating patterns or textures (e.g. tiles with the same design).

Flying over inclined surfaces that will deflect sound waves away from the aircraft.

Keep the sensors clean at all times. Dirt or other debris may adversely affect the effectiveness

of the sensors.

Vision Positioning is only effective when the aircraft is at altitudes of 0.3 to 3 meters.

The Vision Positioning System may not function properly when the aircraft is flying over water.

The Vision Positioning System may not be able to recognize pattern on the ground in low light

conditions (less than 100 lux).

Do not use other ultrasonic devices with frequency of 40 KHz when Vision Positioning system is

in operation.

Vision Positioning System may not be able to stabilize the aircraft when flying close to the

ground (below 0.5 meters) at fast speeds..

Keep the animals away from the aircraft when Vision Positioning system is activated. The sonar

sensor emits high frequency sounds that are only audible to some animals.

Follow the steps below to use Vision Positioning:

1. Toggle the flight mode switch to P-mode.

2. Place the aircraft on a flat surface. Note that the Vision Positioning system cannot

work properly on surfaces without clear pattern variations.

3. Turn on the aircraft. The aircraft status indicator will flash green two times, which

indicates the Vision Positioning system is ready. Gently push the throttle up to lift off

and the aircraft will hover in place.

Flight Recorder

Flight data is automatically recorded to the internal storage of the aircraft. This includes flight

telemetry, aircraft status information, and other parameters. To access these data, connect the

aircraft to the PC through the Micro-USB port and launch the DJI GO app.