Remote Solution Co. Ltd. RC96B 사용자 설명서
RemoteSolution Co. Ltd,
Remote Controller Unit
1.
Application Processor
1.1.
GP565
2.
Application Device
2.1.
TV(U/R), STB
3.
Application KEY
3.1.
TV key
TV Power, Vol+/-, Mute, Input S 5 keys
3.2.
STB Key
STB Power, Google, Page up/down, Live, Vol+/-, Mute, Recent, Ch+/-, Backward, Menu, Guide, Up,
Down, Left, Right, OK, Shows, Movies, Search, REC, REW, Play/Pause, FF, 0~9(Digit), Set S 37keys
Down, Left, Right, OK, Shows, Movies, Search, REC, REW, Play/Pause, FF, 0~9(Digit), Set S 37keys
4.
LED
4.1.
4.1.
Green LED : RF Check output signal and enter setting mode ON/OFF
4.2.
Red LED : Confirm for IR output signal & Confirm the detection of Low battery signal.
4.3.
Back-Light : Turns on when there is movement on the remote control SFade out off after 3 seconds
5.
Main Function
5.1.
5Digit Code Entry.
5.2.
Auto-Search.
5.3.
RF Pairing
5.4.
RF Un-Pairing
5.5.
Battery Monitor
5.6.
Low battery detection
5.7.
Couch Function
5.8.
IR Un-Pairing
5.9.
Version Out
5.10. Device Volume Setting
5.11. RF Information
5.12. Key function table
5.13. Factory Reset
5.11. RF Information
5.12. Key function table
5.13. Factory Reset
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
authority to operate the equipment.
§ 15.105 Information to the user.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.