DASAN Zhone Solutions Inc. 2426Y1 사용자 설명서
zNID 24xxA1 Installation
46
zNID 24xxA1 Hardware Installation Guide
Connect to network
Connecting the SC connectors on fiber based models
Connect the SC connector from the electronics module to the SC connector in
the zNID enclosure.
the zNID enclosure.
Observe the necessary precautions to decrease the risk of exposure to laser radiation.
WARNING! Risk of eye damage. At all times when handling
optical fibers, follow the safety procedures recommended by your
company.
optical fibers, follow the safety procedures recommended by your
company.
AVERTISSEMENT ! Risque de blessure aux yeux. Lors de la
manipulation de fibres optiques, suivez en permanence les
procédures de sécurité recommandées par votre société.
manipulation de fibres optiques, suivez en permanence les
procédures de sécurité recommandées par votre société.
Although DZS optical products have a Class I certification, hazardous
exposure to laser radiation can occur when fibers are connected, disconnected
or broken. Handling of optical fibers without dust caps increases the risk of
exposure. Exposure to either visible or invisible laser light can damage your
eyes under certain conditions.
exposure to laser radiation can occur when fibers are connected, disconnected
or broken. Handling of optical fibers without dust caps increases the risk of
exposure. Exposure to either visible or invisible laser light can damage your
eyes under certain conditions.
1
Remove the fiber service cover by removing the fiber service screw and
then sliding the fiber service cover forward (toward the connection panel
of the zNID).
then sliding the fiber service cover forward (toward the connection panel
of the zNID).
Using your thumb push on the raised marking on the fiber service cover to
slide it off.
slide it off.
For a new unit the fiber service cover will be in a bag, so you will not
need to do this step.
need to do this step.
Figure 11: zNID-GPON-24xxA1 models use SC/APC connector (green)