TOYO ELECTRIC MFG. CO. LTD. GV1000-2D 사용자 설명서
TY‐16F Remote Control
Page 1
User Manual
Battery Installation
1. Remove the remote control and battery from the poly bag.
2. Open the battery cover on the back of the remote by sliding the cover towards the bottom of the remote
3. Clean the battery contacts and also those of the device prior to battery installation.
4. Use only 12V battery type 23A for replacement, use of other batteries may damage remote.
5. Insert negative (‐) end of the battery (see marking on battery) into the spring side of the battery holder
and insert positive (+) end of the battery into other side.
6. Close battery cover by sliding back into place.
Remote Control Operation:
1. The remote has two buttons on the front side:
a. ON/OFF – this is the larger button. Press to turn the set OFF. Press again to turn the set ON.
Note: even when the lights are off, the set still has power to all lamps, to disconnect power, you
must unplug the set.
must unplug the set.
1. FUNCTION – this is the smaller button. Press to change the light pattern to the next function mode.
NOTES:
1. Light set must be plugged into working outlet for remote to function.
2. When using the remote to turn your set ON, there may be a slight delay before the light pattern starts
working.
3. To change the light pattern, it is recommended to wait a few seconds after pressing the FUNCTION button
until you reach the desired pattern.
4. If the lights do not change function or the set does not turn on or off with the remote, see the trouble
shooting section.
5. If there is a power interruption, including if used on a switched outlet, on a timer, or power failure, the
system’s memory will retain the last light pattern displayed.
6. The effective operating distance of the remote is up to
150 feet (45.72 meters)
.