Autostart ANT4420 사용자 설명서

User Guide

 P. 

9 

 

 

• 

Within 3 seconds, press the 

and 

 buttons simultaneously until the 

parking lights go out 

To take the system  o u t   o f   home valet mode: 
• 

Turn the ignition key to the 

 position. 

The system will warn you if someone attempts to start your vehicle while it stands in home valet 
mode. The parking lights will: 

1- Turn 

 then 

; then 

2- Flash twice, pause; then 
3- Flash twice again. 

Turbo Mode 

If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user 
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it 
is shut down by remote control), then shut down the engine. 
Proceed as follows to set the system to Turbo Mode: 
1. With the engine already running, press the 

 button on the transmitter until the parking lights 

come 

. 

2. Remove the ignition key from the ignition switch. The engine will go on running. 
3. Exit the vehicle and close the door. 
4. Press the 

TRUNK 

button to lock the doors; the engine will shut down after 60 seconds of Turbo 

Mode. 

Engine Run Time 

If you have a gas engine, your remote starter can be programmed to run the engine for 

3

, 15, or 

25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be 
programmed to run the engine for 

8

, 20, or 30 minutes (20 minutes default).   

Flashing LED 

The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press 
and hold the 

 and 

 buttons on the transmitter. There will be an initial beep.  Keep 

holding the buttons pressed until you hear another beep.  At that point release the buttons.  The 
LED will toggle to its next state –i.e.: ON/OFF: 
There are three programmable options regarding the flashing LED: 

i. 

The LED flashes once the starter kill is activated (passive or active arming) and will 
turn itself off once the user turns the key to the 

position. 

ii. 

The LED is totally disabled and will not flash –it will turn on solid, however, when in 
valet mode. 

iii. 

The LED will flash once the starter kill is activated but requires pressing the 

 

button to turn itself off.  Failure to press the 

 button will make the LED flash 

even if the key is in the 

 position. 

Multi-car Operation 

This option allows the owner of two vehicles, both equipped with the same remote starter model, to 
control both systems with a single remote control. To control the second vehicle: