Dexin Corp KB2090 사용자 설명서
Operation Guide
Battery Low Indication
When the voltage level of the battery goes down under the preset level, the
scrolling wheel will flash at least three times on moving or clicking the mouse.
Although the mouse can still work for a while, the user, at this time, should
have a new set of batteries ready for replacement. Or, if the user has a
companion charger base, and
Two re-chargeable batteries are inside the mouse, charge the mouse as soon
as possible.
Power off the mouse
1. Be sure the mouse is NOT in sleep mode. If it is, press any key to wake it
up.
2. Press and hold the Connect button on the bottom of the mouse for more
than 2 seconds. (The red light will go off while the Connect button is
depressed.)
3. Wait until the red light flash once. Release the Connect button.
4. Now, the mouse is in power off mode. No operation can be done.
Power on the mouse
To activate the mouse again, press the Connect button on the bottom of
the mouse once. (DO NOT depress the Connect button for more than
1.5 seconds when resuming the mouse from power off mode.) The red
light will turn on, and the mouse is ready for normal operation.
Note: Be sure to press the connect button firmly in procedure, if the connect
button is not depressed steadily the red light will be on before 2 seconds
expire. This will result in a change of channel and ID. Don’t panic, just
re-connect the mouse to the receiver, and follow step 4 again.
Operations on power saving mode
In order to conserve battery power, the mouse is designed to reduce
power consumption gradually from standby mode to sleep mode, if it is not
being used.
Standby mode – Around 2 seconds after the mouse stops moving, it enter
into standby mode.
Sleep mode – If the mouse is left intact for around 8 minutes, it goes to sleep
6