Xircom EAG2919 사용자 설명서
Eagle II GSM Radio Module Technical Manual Preliminary Draft: 08/31/00
18
Part Number: 07100017 version 00.04
© 2000 Xircom, Inc. All rights reserved.
All trademarks and copyrights are the property of Xircom, Inc.
All trademarks and copyrights are the property of Xircom, Inc.
Pin
Number
Signal
Name
Direction
Functionality
Voltage
Level
60
SIM-3 V
To CPE
SIM 3 V output used in conjunction with the SIM-IN signal
to a remote SIM device. Leave signal disconnected if
function is not used.
3 V
Status
7
TX on
To CPE
Transmit ON. Digital output to indicate transmitter power
status. A logic 1 indicates transmit power is on. A logic 0
indicates transmit power is off. Leave signal disconnected
if function is not used.
2.2 V
9
RX on
To CPE
Receive ON. Digital output to indicate receiver power
status. A logic 1 indicates receiver power is off. A logic 0
indicates receive power is off. Leave signal disconnected
if function is not used.
2.2 V
Reserved: Do Not Use
11, 31, 32, 34,35,
36, 37, 38, 39, 41,
43
Reserved
Leave open: do not use.
Subscriber Identification Module (SIM) Carrier
The Eagle II module uses a push/pull SIM carrier (sometimes called SIM reader) and is
installed as a slot on the side of the module. The Eagle II module uses a 3 V removable
“mini-SIM” (or Plug-In) configuration.
installed as a slot on the side of the module. The Eagle II module uses a 3 V removable
“mini-SIM” (or Plug-In) configuration.
The SIM, an integral part of any GSM terminal device, is a “smart card” that is
programmed with subscriber information:
programmed with subscriber information:
!
The user information consists of an International Mobile Subscriber Identity (IMSI)
number, which is registered with the GSM provider, and an encryption Ki
(pronounced "key"). This information consists of a microprocessor and memory
installed on a plastic card.
number, which is registered with the GSM provider, and an encryption Ki
(pronounced "key"). This information consists of a microprocessor and memory
installed on a plastic card.
Note: The SIM is not provided with the Eagle II module. The SIM must be obtained
from the GSM service provider and must be provisioned by the operator for data
and/or voice. Always take care to protect the SIM: the GSM terminal will not operate
without the SIM installed.
from the GSM service provider and must be provisioned by the operator for data
and/or voice. Always take care to protect the SIM: the GSM terminal will not operate
without the SIM installed.
The SIM provides the IMSI for authentication. To gain access to the GSM network, the
network must recognize the IMSI number, and the terminal must be able to properly
decrypt the data sent by the network. The SIM also serves as a buffer for SMS
messages, storing the message for transmission until a radio link is available and
buffering received messages until retrieved.
network must recognize the IMSI number, and the terminal must be able to properly
decrypt the data sent by the network. The SIM also serves as a buffer for SMS
messages, storing the message for transmission until a radio link is available and
buffering received messages until retrieved.
Using a Remote SIM with the Eagle II Module
The Eagle II module also allows the use of a remote SIM—one not installed in the
Eagle II module.
Eagle II module.
!
To utilize a remote SIM, the integrator must provide a suitable SIM connector on the
application
application