Raytheon Anschuetz GmbH High Seas Products MTX9 사용자 설명서
26
Pathfinder Radar Scanners
Fitting the open array to the pedestal
CAUTION
The pedestal unit has a cap fitted over the open array mounting shaft to
protect the protuding co-axial pin. This cap must be left in place until the
open array is fitted to the pedestal.
The pedestal unit has a cap fitted over the open array mounting shaft to
protect the protuding co-axial pin. This cap must be left in place until the
open array is fitted to the pedestal.
1. Remove the cap from the open array shaft. Retain the cap, it will be
required if the open array is removed from the pedestal.
2. Grease the four securing studs.
CAUTION
If the pin is damaged during the following operation you should contact
your service dealer.
If the pin is damaged during the following operation you should contact
your service dealer.
3. Lift the open array into position. Carefully lower the array - to prevent
damage to the mounting pin, ensure the array remains parallel to the
pedestal so that the studs slot into the holes on the pedestal mounting
bracket.
pedestal so that the studs slot into the holes on the pedestal mounting
bracket.
Note: The open array mounting bracket is designed so that the array can only
be fitted to the pedestal in the correct orientation.
be fitted to the pedestal in the correct orientation.
4. Use the four nuts and associated washers supplied to secure the array to the
pedestal as shown in the diagram below.
D4580-1
M8 plain washer
M8 spring washer
M8 nut
Array
Pedestal
154_3c2.p65
13/12/99, 17:02
26