TP-LINK TL-SG3210 사용자 설명서

Date Mode:

Specify the DST configuration in Date mode. This configuration is
one-off in use.



Offset: Specify the time adding in minutes when Daylight
Saving Time comes.



Start/End Time: Select starting time and ending time of
Daylight Saving Time.

Note:

1. When disable the DST, the predefined mode, recurring mode and date mode cannot be

configured.

2. When enable the DST, the default daylight saving time is of European in predefined mode.

4.1.5 System IP

Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.

Choose the menu System→System Info→System IP to load the following page.

Figure 4-7 System IP

The following entries are displayed on this screen:



IP Config

MAC Address:

Displays MAC Address of the switch.

IP Address Mode:

Select the mode to obtain IP Address for the switch.



Static IP: When this option is selected, you should enter IP
Address, Subnet Mask and Default Gateway manually.



DHCP: When this option is selected, the switch will obtain
network parameters from the DHCP Server.



BOOTP: When this option is selected, the switch will obtain
network parameters from the BOOTP Server.

IP Address:

Enter the system IP of the switch. The default system IP is
192.168.0.1 and you can change it appropriate to your needs.