TP-LINK TL-SG3210 사용자 설명서

 



 

If the ports, which are enabled for the GVRP, 802.1Q VLAN, Voice VLAN, STP, QoS, DHCP 

Snooping and Port Configuration (Speed and Duplex, Flow Control), are in a LAG, their 

configurations should be the same. 



 

The ports, which are enabled for the Port Security, Port Mirror, MAC Address Filtering, 

Static MAC Address Binding and 802.1X Authentication, can not be added to the LAG. 



 

It’s not suggested to add the ports with ARP Inspection and DoS Defend enabled to the 

LAG. 

If the LAG is needed, you are suggested to configure the LAG function here before configuring the 

other functions for the member ports. 

1.  Calculate the bandwidth for a LAG: If a LAG consists of the four ports in the speed of 

1000Mbps Full Duplex, the whole bandwidth of the LAG is up to 8000Mbps (2000Mbps * 4) 
because the bandwidth of each member port is 2000Mbps counting the up-linked speed of 
1000Mbps and the down-linked speed of 1000Mbps. 

2.  The traffic load of the LAG will be balanced among the ports according to the Aggregate 

Arithmetic. If the connections of one or several ports are broken, the traffic of these ports will 
be transmitted on the normal ports, so as to guarantee the connection reliability.   

Depending on different aggregation modes, aggregation groups fall into two types: Static LAG 

and LACP Config. The LAG function is implemented on the LAG Table, Static LAG and LACP 

Config configuration pages. 

On this page, you can view the information of the current LAG of the switch. 

Choose the menu Switching→LAG→LAG Table to load the following page. 

 

Figure 5-6 LAG Table 

The following entries are displayed on this screen:

 



Select the applied scope of Aggregate Arithmetic, which 
results in choosing a port to transfer the packets. 

39