TP-LINK TL-SL1351 사용자 설명서
1
Package Contents
The following items should be found in your box:
¾
One
Switch
¾
One power cord
¾
This User's Guide
¾
Rubber footpads for Desk-mount
¾
Rack-mount kit for installing the switch in a 19-inch rack
Note:
Make sure that the package contains the above items. If any of the listed items are
damaged or missing, please contact with your distributor.
damaged or missing, please contact with your distributor.
Chapter 1 Introduction of the Product
This chapter describes the features of the TL-SL1210 / TL-SL1117 / TL-SL1226 /
TL-SL1351 Gigabit Switch. TL-SL1210, TL-SL1117, TL-SL1226 and TL-SL1351
just differ in the number of LED indicators and ports, and all figures in this user
guide are of TL-SL1351.
TL-SL1351 Gigabit Switch. TL-SL1210, TL-SL1117, TL-SL1226 and TL-SL1351
just differ in the number of LED indicators and ports, and all figures in this user
guide are of TL-SL1351.
1.1
Overview of the product
The TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 Gigabit Switch provides you
with a high-performance, low-cost, easy-to-use, seamless and standard upgrade
to boost your old network to 1000Mbps. Increase the speed of your network server
and backbone connections, make Gigabit connection to a server or uplink a
network necessarily.
with a high-performance, low-cost, easy-to-use, seamless and standard upgrade
to boost your old network to 1000Mbps. Increase the speed of your network server
and backbone connections, make Gigabit connection to a server or uplink a
network necessarily.
The TP-LINK TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 features a non-
blocking switching architecture that forwards and filters packets at full wire-speed
for maximum throughput. MAC address auto-learning and auto-aging, IEEE802.3x
flow control for Full Duplex mode and backpressure for Half Duplex mode. It is
compatible with all 10,100, and 1000Mbps Ethernet devices because it is
standard-based.
blocking switching architecture that forwards and filters packets at full wire-speed
for maximum throughput. MAC address auto-learning and auto-aging, IEEE802.3x
flow control for Full Duplex mode and backpressure for Half Duplex mode. It is
compatible with all 10,100, and 1000Mbps Ethernet devices because it is
standard-based.
The TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 is plug-and-play and no
configuration is required. Auto MDI/MDIX cable detection on all ports eliminate the
need for crossover cable or Uplink port. Each port can be used as general ports or
configuration is required. Auto MDI/MDIX cable detection on all ports eliminate the
need for crossover cable or Uplink port. Each port can be used as general ports or