ECS TIGD-CI4 (V1.1) 사용자 설명서
26
Using BIOS
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/1st FLOPPY DRIVE.)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Hard Disk Drives
1st Drive
ST31000340AS
Help Item
Specifies the boot
sequence from the
available devices.
sequence from the
available devices.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Hard Disk Drives
Press <Esc> to return to the Advanced Setup page.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
started.
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Load Default Settings
F1: General Help
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Intel (R) HT Technology (Enabled)
This item enables or disables Intel HT Technology support.
This item enables or disables Intel HT Technology support.
CPU Host Clock (200MHz)
Enables or disables the control of CPU host clock. Enabled will allow the CPU Host
Frequencyitem below to be configurable.
Note: If your system fails to boot after overclocking, please wait for20 seconds
to allow for automated system reboot, or clear the CMOS values to reset the
board todefault values.
Enables or disables the control of CPU host clock. Enabled will allow the CPU Host
Frequencyitem below to be configurable.
Note: If your system fails to boot after overclocking, please wait for20 seconds
to allow for automated system reboot, or clear the CMOS values to reset the
board todefault values.
Quiet Boot (Enabled)
If enabled, BIOS will show a full screen logo at boot; if disabled, BIOS will set
theinitialdisplay mode to BIOS and show the diagnostic POST screen at boot.
If enabled, BIOS will show a full screen logo at boot; if disabled, BIOS will set
theinitialdisplay mode to BIOS and show the diagnostic POST screen at boot.