Davis Instruments Vantage Vue Wireless Weather Station DAV-6250EU 데이터 시트

3

The Vantage Vue console is designed to give extremely accurate readings. As with any 
precision instrument, use care in its assembly and handling. Although installing the console is 
relatively simple, following the steps outlined in this chapter and assembling the Vantage Vue 
correctly from the start will help ensure that you enjoy all of its features with a minimum of 
time and effort.

The Vantage Vue console does not require the use of an AC adapter. You may use the included 
adapter if you wish, but three C-cell batteries (not included) should power a wireless console 
for up to nine months. You can use either of these or both together, with the batteries providing 
backup power for the adapter.

Note: The console will display messages if any of your system’s batteries are low. 

LOW CONSOLE BATTERIES: Replace the console batteries
LOW BATTERY TRANSMITTER (ID#): Replace the battery in your outdoor Integrated Sensor 
Suite (ISS) or any optional transmitting station you may have added.

1. Remove the battery cover located on the back of the console by pressing down on the two 

latches at the top of the cover.

2. Insert three C batteries into the battery channels as shown.
3. Place the battery cover back onto the console and click it closed.
4. Check to make sure the console runs through a brief self-test procedure successfully. 

On power up, the console displays all the LCD segments and beeps three times (four times 
if you have a data logger plugged in). A message displays at the bottom of the console, 
followed by the first screen of Setup Mode. Press DONE to skip the message and enter into 
Setup Mode. Setup Mode guides you through steps required to configure the station. See 
“Setup Mode” on page 6 for more information. 

Note: The console does not recharge the batteries. Because of this, and because NiCad batteries do 

not power the console as long as alkaline batteries, we do not recommend using NiCad 
batteries.