Aurel 650200627 433MHz Radio Component 650200627 데이터 시트
제품 코드
650200627
WIZ-SML-IA
Instruction Manual
Technical features are subject to change without notice. AUR°EL S.p.A does not assume responsibilities for any damage caused by the device’s misuse.
AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana [FC] – ITALY Rev. A, 01-04-2002
Tel.: +390546941124 – Fax: +390546941660 Pag 1 di 3
http://www.aurel.it
- email:
aurel@aurel.it
Data transmission by the WIZ-SML-IA module
The WIZ-SML-IA modules are transceivers for point-to-point data transfer in half-duplex mode. They are the
right solution for all those applications in which the so called “virtual cable” has to be implemented, i.e. the
RF connection of two systems with RS232 output (for instance two PCs.) The WIZ-SML-IA module is
RF connection of two systems with RS232 output (for instance two PCs.) The WIZ-SML-IA module is
available in 12V and 5V version: in the first case the voltage is supplied by a connector with central positive
Vcc, while in the 5V version the voltage is supplied through the input 10 of the data connector. Connected to
the module can be used W232 ADAPTER connector which foresees inside an integrated circuit which shall
the module can be used W232 ADAPTER connector which foresees inside an integrated circuit which shall
care for the conversion of the electric signals from RS232 logic to TTL logic and vice versa.
The module has very small dimensions (4 x 9 cm only) and in its card integrates a 100 kbps XTR transceiver,
a microprocessor which administrates the RF syncronizing protocol and a tuned antenna realized on a
a microprocessor which administrates the RF syncronizing protocol and a tuned antenna realized on a
printed circuit. Besides these components is fitted also a confirguration dip-switch with 6 positions and 2
indication LED (supply and operation).
The module is enclosed in a special case which complies with the EN 61000-4-2 rule.
Module’s 12 V supply
By means of a connector with positive pole at central pin, 9V-15V DC voltage supply
Module’s 5V supply
Input no. 10 of the data connector (see below).
Data connector
1. TX Data (IN)
2. XTR analogic output (OUT)
3. GND
4. GND
5. RX Data (OUT)
6. XTR Carrier Detect (OUT)
7. CTS not in use (OUT)
8. LED (OUT)
9. RTS not in use (IN)
10. 5V DC (IN/OUT)
Front view
1
2
9
10