Crown Battery 1439, 8V Ah lead acid battery 1439 데이터 시트
제품 코드
1439
Visit our website at www.crownbattery.com
CR-165 Commercial Deep Cycle Battery
Crown Battery Manufacturing’s team of research and development
engineers welcome the opportunity to discuss your technical
requirements during the design and specification stage. To access
this technical assistance, please contact
engineers welcome the opportunity to discuss your technical
requirements during the design and specification stage. To access
this technical assistance, please contact
Crown Battery Manufacturing’s Customer Service Department
800.487.2879 | sales@crownbattery.com | FAX 419.334.7124.
800.487.2879 | sales@crownbattery.com | FAX 419.334.7124.
Recommended Charge Profile:
Following discharge, constant current charge the CR-165 battery at 20
amperes until the battery voltage measures between 2.37 and 2.40 volts
per cell (9.48 – 9.6 volts) on charge voltage.
amperes until the battery voltage measures between 2.37 and 2.40 volts
per cell (9.48 – 9.6 volts) on charge voltage.
The constant voltage charge phase begins after the gassing point
(2.37 - 2.42 VPC) is achieved. During the constant voltage phase, the
charger voltage limit is regulated to the gassing point of 2.37 - 2.42 volts
per cell, while the input current is allowed to gradually fall off. When the
input current drops to the finish rate setting of 6 amperes, the charging
phase will change from constant voltage to a sustained 6 ampere constant
current mode. The charging cycle will be terminated by a standard
approved method of charger termination similar to dV/dt or 3.5 to 5 hours
from the gassing point, with factors such as ambient temperature, battery
condition and depth of discharge affecting the charge completion time.
(2.37 - 2.42 VPC) is achieved. During the constant voltage phase, the
charger voltage limit is regulated to the gassing point of 2.37 - 2.42 volts
per cell, while the input current is allowed to gradually fall off. When the
input current drops to the finish rate setting of 6 amperes, the charging
phase will change from constant voltage to a sustained 6 ampere constant
current mode. The charging cycle will be terminated by a standard
approved method of charger termination similar to dV/dt or 3.5 to 5 hours
from the gassing point, with factors such as ambient temperature, battery
condition and depth of discharge affecting the charge completion time.
The CR-165 battery should receive a full recharge following the completion
of each discharge, along with a monthly equalization service charge.
During the equalization charge cycle the finish rate charge time is
extended by 3 hours (6.5 to 8 hours from the gassing point).
of each discharge, along with a monthly equalization service charge.
During the equalization charge cycle the finish rate charge time is
extended by 3 hours (6.5 to 8 hours from the gassing point).
The charge factor of the standard recharge should be equal to or greater
than 1.07 (107%). The charge factor of the equalizing cycle should be equal
to or greater than 1.15 (115%).
than 1.07 (107%). The charge factor of the equalizing cycle should be equal
to or greater than 1.15 (115%).
Please contact Crown Battery Manufacturing Company’s engineering
department with any questions regarding this charge profile specification.
department with any questions regarding this charge profile specification.
© Copyright, Crown Battery Manufacturing Company 2009
Form No. TDS-47-1439-0609
Data are nominal and should not be construed as maximum or minimum values for
specification or for final design. Data for this product type may vary from that shown herein.
specification or for final design. Data for this product type may vary from that shown herein.
10.75 (273.05)
10.31 (261.88)
7.13 (181.10)