Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

[Corresponding model type]: Airplane/glider, 2 ailerons or more

This function is used when you want to mix the 

camber flaps with elevator operation. When used,  

the flaps are lowered by up elevator, and lift is 

increased.

● In-flight mixing can be turned ON/OFF by assigning 

this to a switch. (Always ON at [--] setting)

● The mixing rate can be adjusted.

● The point that has little effect near the neutral 

position of the elevator stick can be adjusted. 

(Glider only)

  Move the cursor to the up or down mixing 

rate item for each servo and touch the RTN 

button to switch to the data input mode. 

Adjust the rate independently by scrolling 

the touch sensor. 

  Initial value: 0%
  Adjustment range: -100~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to end the adjustment 

and return to the cursor mode.

  Move the cursor to the [ACT] item and touch 

the RTN button to switch to the data input 

mode. Select the ACT mode by scrolling the 

touch sensor. 

*The display blinks.

  Touch the RTN button to activate the 

function and return to the cursor mode. (ON 

is displayed.)

  When setting a switch, move the cursor to 

the [SW] item and touch the RTN button to 

call the selection screen. Select the switch 

and set its ON direction. (Always ON at "--" 

setting)

*For a description of the switch selection method, see the 

description at the back of this manual.

  Move the cursor to the [RANGE] item and 

hold the elevator stick to the desired position 

(upper or lower side) and then touch the RTN 

button for one second to set the range. 

*The mixing does not work near neutral of the  elevator stick.

  Initial value: 0%
  Adjustment range: 0~100%

(Glider: Currently selected condition name)

● Select [ELE to CAMBER] at the Model 

menu and access the setup screen 

shown below by touching the RTN 

button.

*The display screen is an example. 

The actual screen depends on the 

model type.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page