Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

RUDDER 1

Winglet

at Flying wing

(               )

RUDDER 2

Winglet

at Flying wing

(               )

[Corresponding model type]: Airplane/glider, Flying wing only

This function adjusts the left and right rudder 

angles of airplanes with winglets.

Winglets are used to improve the efficiency of 

aircraft by lowering the lift-induced drag caused by 

wingtip vortices. The winglet is a vertical or angled 

extension located at the tip of each wing.

 Winglets work by increasing the effective aspect 

ratio wing without adding greatly to the structural 

stress and hence necessary weight of its structure 

- an extension of wing span would also permit 

lowering of induced drag, though it would cause 

parasitic drag and would require boosting the 

strength of the wing and hence its weight. There 

would come a point at which no overall useful 

gains would be made. A winglet helps to solve this 

by effectively increasing the aspect ratio without 

adding to the span of the wing.

(Rudder 1/2)
● The travel during rudder stick operation 

can be individually adjusted.

● Select [WINGLET] at the Model menu 

and access the setup screen shown 

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

  Move the cursor to the item you want to 

adjust and touch the RTN button to switch to 

the data input mode.

  Adjust the rate by scrolling the touch sensor. 
  Initial value: +100%
  Adjustment range: -120~+120%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to return to the cursor 

mode.

*If the mixing direction is reversed, change the mixing rate 

polarity (+ or -).