Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name 

and return to the Model 

menu by touching the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s 

pushed.

[Corresponding model type]: Airplane, general

This function is used when you want to mix 

elevator operation with rudder operation. It is used 

to correct undesirable tendencies when rudder is 

applied in rolling maneuvers such as, knife edge 

flight.

● Mixing during flight can be turned ON/OFF by 

setting a switch. (Always ON at [--] setting)

● Link mixing can be set: Links this mix to other mixes.

●  Select  [RUD  to  ELE]  at  the  Model 

menu and access the setup screen 

shown below by touching the RTN 

button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

  Move the cursor to the [ACT] item and touch 

the RTN button to switch to the data input 

mode. Select the ACT mode by scrolling the 

touch sensor. 

*The display blinks.

  Touch the RTN button to activate the 

function and return to the cursor mode. (ON 

is displayed.)

  When selecting a switch, move the cursor to 

the [SW] item and touch the RTN button to 

call the selection screen. Select the switch 

and set its ON direction. (Always ON at "--" 

setting)

*For a description of the switch selection method, see the 

description at the back of this manual.

[Curve rate setting]
1. Move the cursor to the curve rate setting 

item (left side) you want to adjust and touch 

the RTN button to switch to the data input 

mode.

  Adjust the rate by scrolling the touch sensor.
  Adjustment range: -100%~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to end the adjustment 

and return to the cursor mode.

2. Repeat this procedure for each point.
[Moving curve point]
1. Move the cursor to the curve point setting 

item you want to adjust and touch the RTN 

button to switch to the data input mode.

  Adjust the curve point by scrolling the touch 

sensor.

  Adjustment range: Up to 2.5% in front of the 

adjoining point

*When the RTN button is touched for one second, the curve 

position is reset to the initial value.)

  Touch the RTN button to end the adjustment 

and return to the cursor mode.

2. Repeat this procedure for each point.

[Deleting/returning curve point]
  Move the cursor to the curve point setting 

item you want to delete/return and touch 

the RTN button for one second.

  When selecting the link mixing, move the 

cursor to the [LINK] item and touch the RTN 

button to switch to the data input mode. 

Select the ON mode by scrolling the touch 

sensor. 

*The display blinks.

  Touch the RTN button to set the link mode 

and return to the cursor mode.