Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

This function adjusts the pitch operation curve 

for each flight condition to optmize the model's 

performance in relationship to the throttle stick 

position.

*A simple curve can be created by reducing the number of 

input points to two or three, and then entering the specified 

value at the corresponding points.

*For normal curve, create a basic pitch curve centered 

about hovering. Use this function together with the THR 

Curve (Normal) function and adjust the curve so that up/

down control is best at a constant engine speed.

*For the high side pitch curve, set the maximum pitch 

so that it does not overload the engine. For the low side 

pitch curve, create curves matched to loop, roll, 3D, and 

other purposes and use the idle up curves according to the 

performance.

*The throttle hold curve is used when executing auto 

rotations.

When actually starting the engine and flying, 

always set the idle up condition switch to OFF 

and start the engine at idle.

● Select [PIT CURVE] at the Model menu

and access the setup screen shown

below by touching the RTN button.

● Pitch curve copy

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Currently selected condition name)

 Move the cursor to COPY and touch the RTN

button to switch to the data input mode.

Select  the  copy  destination  condition  by

scrolling the touch sensor and touch the RTN

button. Select the [YES] and touch the RTN

button.

● curve rate

● curve point

[Curve rate setting]
1. Move the cursor to the curve rate setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

 Adjust the rate by scrolling the touch sensor.
 Initial value: P1: -100%, P2: -50%, P3: 0%, P4:

+50%, P5: +100%

 Adjustment range: -100%~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.

 Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat  this  procedure  for  each  point  as

desired.

[Moving curve point]
1. Move the cursor to the curve point setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

 Adjust the curve point by scrolling the touch

sensor.

 Initial value: P1: (0%), P2: 25%, P3: 50%, P4:

75%, P5: (100%)

 Adjustment range: Up to 2.5% in front of the

adjoining point

*When the RTN button is touched for one second, the curve 

position is reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat  this  procedure  for  each  point  as

desired.

[Deleting/returning curve point]
1. Move the cursor to the curve point setting

item you want to delete/return and touch

the RTN button for one second.

*The graph display includes the pitch 

trim operation.