Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

Throttle curve function adjusts the throttle 

operation curve for each condition to optimize the  

engine speed to throttle stick movement.

The Throttle Hover function trims the throttle 

near the hovering point. Normally, use it with 

hovering conditions. Changes in rotor speed 

accompanying changes in the temperature, 

humidity,  and  other  flight  conditions  can  be 

trimmed. Adjust the throttle so that rotor rotation is 

most stable. More precise trimming is also possible 

by using this function along with the Hover Pitch 

function.

● Select [THR CURVE] at the Model menu

and access the setup screen shown

below by touching the RTN button.

*The graph display includes the throttle 

hover trim operation.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Currently selected condition name)

● Throttle curve copy

● curve rate

● curve point

*Normal curve creates a basic curve centered around 

hovering. Use it along with the normal pitch curve and 

adjust so that up/down control results in a constant engine 

speed.

*Set a idle up curve that maintains a constant speed at all 

times, even during operation which reduces the pitch 

performed in flight. Create a curve matched to loop, roll, 

3D, or other purposes and the idle up curve according to 

the performance.

When actually starting the engine and flying, 

always set the idle up condition switch to OFF 

and start the engine at the idle.

[Deleting/returning curve point]
1. Move the cursor to the curve point setting

item you want to delete/return and touch

the RTN button for one second.

 Move  the  COPY  item  and  touch  the  RTN

button to switch to the data input mode.

Select  the  copy  destination  condition  by

scrolling the touch sensor and touch the RTN

button. Select the [YES] and touch the RTN

button.

[Curve rate setting]
1. Move the cursor to the curve rate setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

 Adjust the rate by scrolling the touch sensor.
 Initial value: P1: 0%, P2: 25%, P3: 50%, P4: 75%,

P5: 100%

 Adjustment range: 0%~100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat  this  procedure  for  each  point  as

desired.

[Moving curve point]
1. Move the cursor to the curve point setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

 Adjust the curve point by scrolling the touch

sensor.

 Initial value: P1: (0%), P2: 25%, P3: 50%, P4:

75%, P5: (100%)

 Adjustment range: Up to 2.5% in front of the

adjoining point

*When the RTN button is touched for one second, the curve 

position is reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

2. Repeat this procedure for each point as desired.