Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 데이터 시트

The NiMH battery HT5F1800B is only for 

your T14SG. Do not use this battery for other 

equipment.

Be sure to use the attached special charger  to 

charge the battery.

*If you take the NiMH battery HT5F1800B out of the 

transmitter, you can use the optional quick charger CR-2000 

corresponding to NiMH battery.

[Method of charging battery]

*Connect to AC outlet 

specified.

Receiver Batt.

Charging display

To T14SG charge 

  connector

Transmitter Batt.

Charging display

1. Connect the special charger to the wall 

socket (AC outlet).

2. Connect the connectors to the T14SG 

charging jack.

*Confirm that the charging indicator, LED lamp, is on.
*Turn off the transmitter while charging the battery.

3. Remove the battery after 15 hours.

*Battery charging will not automatically stop. Remove the 

battery and transmitter from the charger and remove the 

charger from the wall socket.

*It is recommended to reactivate the battery by cycling   

several times if the battery has not been used for a long 

period. 

*In the case of NiMH/NiCd batteries, you may find poor 

performance of the battery if you have used the battery 

only for a short period or if you repeat charging while the 

battery is not fully discharged. It is suggested to discharge 

the battery to the recommended level after use. It is also 

recommended to charge the battery just before use. 

Before charging batteries, read the "Cautions for handling battery and battery charger" in the section 

"NiMH/NiCd Battery Safety and Handling Instructions".