Bunn 1SH & 2SH STAND 사용자 설명서

Page 5

Test Procedures

1.  Disconnect the stand from the power source.

2.  Remove the wires from the circuit breaker.

3.  Check for continuity between the circuit breaker 

terminals. Continuity must be present between the 

terminals.

If continuity is present as described the circuit breaker 

is functioning properly.

If continuity is not present as described, press reset 

button and repeat step #3, if continuity is not present 

as described, replace the circuit breaker.

Removal and Replacement:

1.  Remove the wires from the circuit breaker.

2.  Compress the clips on the back side of the recep-

tacle bracket and gently push the circuit breaker 

through the opening in the receptacle bracket.

3.  Push the new circuit breaker into the opening in 

the  receptacle  bracket  until  the  clips  snap  into 

position.

4.  Reconnect the wires to the circuit breaker.   

5.   Refer to Fig. 3 when reconnecting the wires.

FIG. 3 CIRCUIT BREAKER TERMINALS

P1330

BLU/BLK to Transformer #12

BLU/BLK to Rectifier "AC"

FIG. 4 RECEPTACLE ASSEMBLY

Location:

The receptacle assembly is located on the lower 

front of the receptacle bracket just below the circuit 

breaker.

Test Procedures:

1.  Clean or replace spring contacts.

Removal and Replacement:

1.  Disconnect the stand from the power source.

2.  Disconnect the wires from the receptacle assem-

bly.

3.  Remove the two #6-32 flat head screws securing 

the receptacle to the receptacle bracket.

4.  Remove and discard receptacle.

5.  Install  new  receptacle  in  the  receptacle  bracket 

and secure with two #6-32 flat head screws..

6.   Refer to Fig. 5 and reconnect the wires. 

FIG. 5 RECEPTACLE TERMINALS

P1380