Snom m9 사용자 설명서

14

15

Before  first  use,  the  handset  battery  should  be  charged 
fully.   This will take approximately 8 hours.  

1.  Lift off the battery cover. 
2.  Insert the battery pack with the electrodes in the top left corner.  

Replace the cover.

3.  Connect the 5.9 V power supply of the charger to the wall outlet 

first, then to the charger, and place the handset in the charger. 

snom

     

rechargeable

Lithium-Ion

battery

 

 

    

 

– lit when on

 

– flashes during firmware update 

 

– lit  when call in progress

 

– blinks  slowly  when  waiting  for   

handset registrations

 

– lit when the base 

station is registered

 

– flashes during boot, 

indicating that the base 
station has received an IP 
address

1.  When the handset is ready for use, connect one end of the network 

cable with the NET port on the back of the base station and the 
other end to a LAN port in your network (switch, router, etc.).

2.  Connect the 5 V power converter to the wall outlet first, THEN to 

the base station.

3.  The power indicator comes on and the base station begins to boot.   
4.  When the base station has booted up, the "Call" LED will start 

to blink, indicating that the base station is waiting for handset 
registration.