Toshiba Magnia Z300 사용자 설명서
System Configuration Setup
Configuring MegaRAID IDE
165
c
Boot sector virus protection
c
DMA transfers
c
Enable / Disable Buzzer
NOTE: These options apply to all drives attached to Mega-
RAID IDE.
RAID IDE.
Help section
The Help section of the Setup window screen displays hints on
available options. The Help section also provides a list of keys that
you can use to perform tasks, such as auto configuring, creating or
deleting an array.
available options. The Help section also provides a list of keys that
you can use to perform tasks, such as auto configuring, creating or
deleting an array.
Switch Windows (TAB)
The <TAB> key is used to switch the control back and forth
between the Array Information and the Physical Drive Informa-
tion windows.
between the Array Information and the Physical Drive Informa-
tion windows.
Auto Configure Stripe (F1)
Press the <F1> key to auto configure a Stripe array. When you do
this, MegaRAID IDE automatically creates a Stripe based array
based on the available physical drives attached. The Stripe size is
set for the optimum level (64 KB).
this, MegaRAID IDE automatically creates a Stripe based array
based on the available physical drives attached. The Stripe size is
set for the optimum level (64 KB).
Auto Configure Mirror (F2)
Press the <F2> key to run auto configuration. When you do this,
MegaRAID IDE automatically creates arrays based on the avail-
able physical drives. A minimum of two free physical drives are
required for mirroring.
MegaRAID IDE automatically creates arrays based on the avail-
able physical drives. A minimum of two free physical drives are
required for mirroring.