Network Technologies Rackmux-D15/17 사용자 설명서

 

An NTI RACKMUX with a 17” monitor supports resolutions up to SXGA (1280 x 1024) with a refresh rate at between 55 and 76Hz.    
When a 15” monitor is present, support for resolutions up to XGA (1024 x 768) apply with a refresh rate at between 55 and 76Hz.  
The quality of the image on the LCD monitor is adjustable using an On Screen Display (OSD) menu using the control buttons on 
the RACKMUX.     

 

The RACKMUX has 5 standard control buttons and a power LED. The 5 standard control buttons operate as follows: 

 

• The 

Power button turns the RACKMUX LCD and backlight ON and OFF as desired.    

 

• The 

Power LED located immediately below the Power button is a dual color  

        LED.     It will illuminate with a green color when the RACKMUX is powered  
        ON and working properly.     It will illuminate with a red color if the RACKMUX  
        is powered ON but there is no input signal detected.     
 
• The 

Menu button is used to bring up the OSD menu where the various 

settings of the LCD display can be adjusted.  Once the OSD screen is 
displayed,  the Menu button is used to make selections within the menus.    
See "OSD Control Menu"  (below) for more on LCD display settings. 

 

• The 

Up and Down Arrow buttons are used to navigate through the menus.   

Move the cursor up or down as desired to highlight an item for selection.    

        Once an item is highlighted,  pressing the Menu button will select it.    

• The 

Select button is used to make selections within the OSD menus when  the OSD menu is ON.  When the OSD menu is 

OFF,  the Select button will act as an Auto Adjust button to keep the user from having to use the menus to adjust the quality 
of the image on the monitor.   

 
 

 
The OSD (On Screen Display) Menu enables the user to select the desired characteristics of the LCD display.   To activate the 
OSD Menu,   press the Menu button (above).    To turn the Menu back OFF,  either select "EXIT" from the main menu or just wait  
10-60 seconds and it will automatically be cleared from the screen.     

 
 
 
 
 
 
 
 
 
 
 
Selection 

Brightness/Contrast Increase/decrease 

panel brightness/contrast level 

1-100 

Color 

R,G,B color temperature control 1-100 

Position 

• 

Video Image horizontal and vertical position control 

• Clock 

setting 

• Phase 

control 

1-100 

Setup 

• 

Control OSD Image position on screen 

• 

Set time OSD will stay on screen before auto shutoff 

• 

Select the language of the OSD menu  

-- 
10 to 60 seconds 
Several languages (see page 8) 

Exit 

Exit from the OSD control menu