Netopia R310 사용자 설명서

Configuring TCP/IP on a Windows computer requires the following:

■

An Ethernet card (also known as a network adapter)

■

The TCP/IP protocol must be “bound” to the adapter or card

If you configure your Netopia R310 using Smar tStar t, you can accept the dynamic IP address assigned by your 
router. The Dynamic Host Configuration Protocol (DHCP) ser ver, which enables dynamic addressing, is enabled 
by default in the router. If your PC is not set for dynamic addressing, Smar tStar t will offer to do this for you 
when you launch it. In that case, you will have to restar t your PC and relaunch Smar tStar t. If you configure your 
PC for dynamic addressing in advance, Smar tStar t need only be launched once. To configure your PC for 
dynamic addressing do the following:

New IP Address screen. If you want to change the router’s 
IP address, you enter the new IP address, the subnet 
mask, and the router’s serial number in this screen. 
Remember, the serial number is on the bottom of the 
router.

Note: Forcing a new IP address may turn off the Netopia 
R310’s IP address ser ving capabilities, if you assign an IP 
address and subnet mask outside the router’s current IP 
address ser ving pool. The Netopia R310 does not allow an 
invalid address to be ser ved. Use this option with caution.

When you have done this, click Next.

Smar tStar t forces the new IP address into the router, tests 
the connection, and then resets the router.

Smar tStar t then returns you to the 

.