Enterasys Networks MATRIX 7H4385-49 사용자 설명서
Installation Site Requirement
3-2 Installation
Installation Site Requirement
The 7H4385‐49 must be installed in a Matrix E7, N1, N3, N5, or N7 chassis located in a
Restricted Access Location (RAL). This location should only be accessible by people that
have been trained or are technically competent enough to be aware of potential risks of
accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or
locked cabinet meet this requirement.
Restricted Access Location (RAL). This location should only be accessible by people that
have been trained or are technically competent enough to be aware of potential risks of
accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or
locked cabinet meet this requirement.
Unpacking the DFE Module
Unpack the DFE module as follows:
1.
Open the box and remove the packing material protecting the DFE module.
2.
Verify the contents of the carton as listed in
3.
Remove the tape seal on the non‐conductive bag to remove the DFE module.
4.
Perform a visual inspection of the DFE module for any signs of physical damage.
Contact Enterasys Networks if there are any signs of damage. Refer to “
Contact Enterasys Networks if there are any signs of damage. Refer to “
on page xviii for details.
Warning: Install this module in a Matrix E7, N1, N3, N5, or N7 chassis that has been
installed in a Restricted Access Location only. Access to the equipment by users must be
restricted through the use of a tool or lock and key or other means of security and is
controlled by the authority responsible for the location.
installed in a Restricted Access Location only. Access to the equipment by users must be
restricted through the use of a tool or lock and key or other means of security and is
controlled by the authority responsible for the location.
Advertencia: Instalar este modulo en un Matrix E7, N1, N3, N5, o N7 que ha sido
localizado en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
localizado en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem E7, N1, N3, N5, oder N7
Chassis, wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich
zu den Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen
Sicherungen geschützt und durch einen Verantwortlichen kontrolliert werden.
Chassis, wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich
zu den Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen
Sicherungen geschützt und durch einen Verantwortlichen kontrolliert werden.
Table 3-1 Contents of 7H4385-49 Module Carton
Item
Quantity
7H4385-49
1
Installation Guide
1
Customer Release Notes
1